2 hoops for earrings
4 small jump rings (circles not ovals)
2 pairs of pliers
These are a sinch to make. Just get these fragments by Tim Holtz:
Drill a hole
Glue the back of the fragment to some cute scraps of paper using Diamond Glaze Sand the edges of the paper and Mod Podge over the back (on the paper) to seal it
Poke a hole in the paper where you drilled but DON'T FOLLOW THE PICTURE, instead, do it from the back so it doesn't push the paper off the fragment. Learn from my mistake ;)
Push the jump ring through the hole from the back so you don't push the paper off the fragment but then continue pushing it though until the opening of the jump ring is in the back.
Add a 2nd jump ring and close the first one with your pliers. At this point make sure you're kids aren't around because if you're like me you may curse a little. Open the 2nd jump ring, add the hoop to it then close it with your pliers. Harder than it sounds. At least for me anyway!
The 2nd jump ring will make it so the earring dangles correctly. And there you have it!